Understanding the 94B-4 Series Backwash Controls

The 94B-4 Series line of controls, are solid-state filter backwash controls, capable of operating one master valve, and up-to 12 backwash valves. The control will initiate a backwash cycle after reaching a pre-determined time or by receiving a signal from the pressure switch indicating a dirty filter condition. ( LCD Monitor models are also available through the 94B-4L, 94B-8L, and 94B-12L line ).

The 94B-4 Backwash Control is shipped ready for most normal installations. However, certain situations will require fine tuning of the P.D. Delay, timer mode, and last station backwash settings. This is accomplished by locating the DIP Switch assembly on the back of the control panel ( see image below ) and making final adjustments.

PC BOARD DIP SWITCH

*If you have a 4-tank system, then all DIP Switches must be down and #4 should be up.

Depending on the number of tanks you have, that will dictate which switch must be up.

A. LAST STATION SWITCH

B. TIMER MODE SWITCH

C. SLAVE SWITCH

D. PRESSURE DIFFERENTIAL SWITCH DELAY

E. OFF-POSITION OF DIP SWITCH

Wiring Diagram

Use image to make all wiring connections for standard two-wire solenoid valves.

If you need help and direction in running and making sure your controls are operating the way they should, consult an Everfilt Applications Engineer and we'll take you through the process to ensure you're up and running. (800) 360-8380 | (951) 360-8380 or everfilt@everfilt.com FOLLOW US: FB | INSTAGRAM

Everfilt : Need Customer Support for Your 94B-4 Backwash Control Panel?